Knowledge Base
Support
Support for Biomomentum's Products
Recent Articles
Attempted to get Child Nodes on invalid node refnum (Error code: -2633)
If the Mach-1 Motion application fails to load and displays error -2633: "LabVIEW: Attempted to get Child Nodes on invalid node refnum", this may be due to a missing multiaxis load cell calibration file (FTXXXXX.cal). Solution 1: Reset Multiaxis Load ...Issues with Trend Micro Antivirus Software
There have been a few issues noticed with specifically Trend Micro antivirus software: https://www.trendmicro.com/. In particular, this antivirus software interferes with incoming force and position data from the Mach-1. Some examples include: ...Main differences when using a spherical vs cylindrical indenters
Here are the main differences when using a spherical vs cylindrical indenter: Spherical Shaped Indenter Cylindrical Shaped Indenter A model should be used to fit to this data (Hayes, Hertz, Sneddon). See Mach-1 Analysis User Manual for more ...Multi-axis Load Cell FAQ
Note that for version 4.5.0.1 of Mach-1 Motion or later with an ESP302 controller + interconnection board + load cell smart connectors, the load cell calibration matrix is hardcoded and must be modified by a Biomomentum technician. How are multi-axis ...No data stream/No Load Cell Detected when opening Mach-1 Motion or freeze when clicking "Start", then Error -88705 after a few minutes
The general Error -88705 can be solved using the following method: https://support.biomomentum.com/portal/en/kb/articles/daqmx-self-test-error-88705 In this specific case of the error, there is a blank screen (no load cell data is shown) for a few ...
Popular Articles
DAQmx Self-Test (Error: -88705)
NOTE: in Mach-1 Motion version 4.5.0.1+ (ESP302), the software will automatically search through all DAQ ports. The method below is not necessary. This error is usually caused by having an incorrect DAQ# in the Mach-1 Motion configuration file. ...For access to more articles, create an account using the "Sign Up" button
To view Biomomentum's Knowledge Base articles visible only to registered users, you must create an account. Click "Sign Up" in the top right of the screen to get started.No data stream/No Load Cell Detected when opening Mach-1 Motion or freeze when clicking "Start", then Error -88705 after a few minutes
The general Error -88705 can be solved using the following method: https://support.biomomentum.com/portal/en/kb/articles/daqmx-self-test-error-88705 In this specific case of the error, there is a blank screen (no load cell data is shown) for a few ...Stage does not move (Axis 1: Motor Not Enabled)
In the case where the stage does not move when "Up" or "Down" are clicked, it is likely that the stage has been turned OFF. To turn the stage back ON, click "Enable Axis" or "Enable Axes" in the "Manual Controls" window. Stages will automatically ...Verify the actuator controller connection and/or power (Error code: -1073807339)
Error code: -1073807339 can appear for multiple reason. The most common reason is that the ESP controller power button is off. To fix this error, reach behind the Motion Controller and activate the switch powering ON the ESP controller. Other ...